
The demanding and often hectically busy N3 route from Johannesburg to Durban provided the ideal proving ground for the largest and most comprehensive truck test ever staged on the African continent with 19 equally laden interlinks making the trip down and back again in the 2026 Focus on Transport Truck Test.
Strictly monitored by C-Track telematics with fuel and oil tested for contaminants before and after the run by Wear Check, the results provide an insight to what it actually means to transport good around the country.
While fuel consumption is always a factor in transport costs, a much more significant indicator for fleet operators is the Payload Productivity Factor calculated thus: Payload Productivity Factor = payload (tons) x Ø speed (km/h) / (Ø fuel consumption (ℓ/100km) + Ø AdBlue consumption (ℓ/100km) x (AdBlue price (20.00).

The most fuel-efficient truck in this year’s Focus Truck Test used 43,47 litres of diesel per 100 km, while the thirstiest consumed 61,85 litres over the same Johannesburg to Durban and back route, carrying a near-identical load. For a long-haul operator, that difference is large enough to separate a profitable fleet from a struggling one.
Truck Test 2026, powered by Engen and organised by Focus on Transport & Logistics, brought together 19 extra-heavy trucks from 13 manufacturers. Each 6×4 truck tractor pulled an identical Afrit tautliner trailer combination at a gross combination mass of about 56 tonnes, and all the vehicles ran on diesel supplied by Engen to keep fuel specification out of the equation. TruckScience handled data collection and analysis, with technical oversight from Truck Test Technical Director Jayesh ‘Tiny’ Daya.
Productivity and economy at the top
The published results, which cover actual rather than simulated runs, rank trucks on payload productivity, a measure of how effectively a vehicle turns fuel and time into delivered freight. The MAN TGX 26.520 BL SA GM finished first with a score of 48,9 and burned 45,22 l/100 km, the second-best consumption figure recorded. The Mercedes-Benz Actros 2652LS HT took second place on productivity at 45,9, though its consumption of 49,87 l/100km sat mid-table. The Scania R520 A6X4NA was third at 44,9 and posted the third-lowest consumption at 45,78 l/100km.
The lowest consumption of all belonged to the Scania R550 A6X4NZ at 43,47 l/100 km, which also had the highest torque in the field at 2 800 Nm. It ranked only 11th on productivity, however, with a score of 40,9. The result suggests that frugality alone did not carry the day, and that journey times and average speeds counted heavily in the productivity ranking.
The 56-tonne combinations carried payloads that varied by less than a tonne across the field, from 35 951 kg for the Iveco S-Way to 36 926 kg for the Sinotruk Howo-Max. Because loads were so closely matched, the differences in fuel consumption can be attributed largely to the trucks themselves rather than to what they were hauling.
Power on paper, efficiency on the road
The figures also challenge the assumption that more power means better performance. The Foton Auman 560 Air AMT, with 412 kW, was among the most powerful trucks entered, yet the two Foton variants finished last and second last on productivity and recorded the highest consumption, at 59,12 and 61,85 l/100km. The only difference between them was the axle ratio, and the variant with the 3.083 ratio used 2,73 l/100km more than the 2.846 version.
However, Foton did issue a statement saying incorrect settings for operating software were found post event and wind deflectors were not correctly set on both trucks – both of which were new with very low mileage that may have added to the fuel consumption figures.
Variants of the same model produced different outcomes elsewhere. The MAN TGX Euro 5 derivative used 49,13 l/100 km, almost four litres more than the standard MAN TGX, and scored 44,3 on productivity. The Mercedes-Benz Actros RE variant consumed 52,71 l/100 km against 49,87 for the HT and the Volvo FH520 (51,84 litres) used more fuel than the Volvo FH500 (49,66) despite its higher output designation.
The Iveco S-Way had the highest peak power in the test at 413 kW and returned 49,96 l/00 km, placing it sixth on productivity at 43,9. Chinese-built entries such as the Shacman X6000, FAW J7 and Sinotruk Howo-Max were spread between 49,36 and 53,58 /100km, with the FAW J7 28,550 recording the best consumption of that group.

What the gap means in rand terms
Engen illustrated the stakes with simple arithmetic. A truck covering 150 000 km a year that saves one litre per 100 km burns 1 500 litres less diesel annually, which at an illustrative R30 a litre is R45 000. Across a 100-vehicle fleet, that becomes R4,5-million.
Applying the same assumptions to the test results shows how much the choice of truck can matter. The 18,38 l/100 km separating the best and worst consumption figures would amount to roughly 27 570 litres a year per truck, or about R827 000 at R30 per litre. Even the 1,75 litre difference between the MAN TGX, the productivity leader, and the Scania R550, the consumption leader, represents about R78 750 per truck each year.
Sharveen Maharaj, Commercial General Manager at Engen, said the impact reaches well beyond transport operators. “Most people don’t think about trucks when they look at the price of their groceries, but almost everything we consume has been transported by road at some point,” he said. “Every litre of diesel has a cost, and those costs don’t stop with the transport operator. They work their way through the supply chain.”
A route that punishes engines and brakes
The Johannesburg to Durban corridor was chosen partly because of how hard it works a vehicle. Jim Ward, CEO of Jim Ward Consulting, described conditions that can change dramatically within a single day of driving. A truck can leave a cool, overcast coastal town at sea level at 18 degrees, travel five or six hundred kilometres inland and climb 1,6 kilometres in altitude, only to arrive in the Free State at more than 34 degrees.
“Heat lowers air density and oxygen reduces with altitude. That’s the double whammy,” Ward said, drawing a comparison with aviation, where hot and high conditions are among the most demanding for take-off. He said an intercooled turbo diesel helps, but with roughly 15% less oxygen available, the engine control unit still has to balance boost and fuel, and factors such as stop-start traffic, reflected road heat and exhaust gas recirculation alter the heat balance further.
“A combination that is comfortably powered at the coast, he noted, can struggle to pull away on a gradient from a standstill on a hot day at 1 600 metres, and in some conditions the route pushes engine management and braking systems close to their limits.”
Beyond the league table

For Maharaj, who drove part of the route himself, the exercise carries a broader message. “It carries someone’s business, whether it could be a small business or a big business. It carries someone’s livelihood,” he said of the country’s trucking sector, pointing to the roughly 400 000 trucks on South African roads and the millions of people who depend on them.
He argued comparative testing helps operators think differently about their businesses. “In transport, every kilometre, every litre, every inch of a tyre that is used creates a burden of cost for the business and for the economy at large,” he said. Truck Test, in his view, moves the conversation from manufacturers’ claims to measured performance. “It puts trucks to work under real operating conditions and generates meaningful data that fleet owners can use when making purchasing decisions.”
For fleet buyers, the results point to a simple conclusion: the figures on a specification sheet are a poor guide to what a truck will do on the N3 with 36 tonnes behind it.
| Truck | Payload Productivity | Payload (kg) | Fuel consumption (ℓ/100km) | Power (kW) | Torque (Nm) |
| MAN TGX 26.520 BL SA GM | 48,9 | 36 578 | 45,22 | 382 | 2 600 |
| Mercedes-Benz Actros 2652LS HT | 45,9 | 36 403 | 49,87 | 380 | 2 600 |
| Scania R520 A6X4NA | 44,9 | 36 612 | 45,78 | 382 | 2 650 |
| MAN TGX 26.520 BL SA GM Euro 5 | 44,3 | 36 784 | 49,13 | 382 | 2 600 |
| Volvo FH500 (Euro 6) | 44,0 | 36 251 | 49,66 | 368 | 2 800 |
| Iveco S-Way AS440S56TZ | 43,9 | 35 951 | 49,96 | 413 | 2 500 |
| Shacman X6000 560 hp | 43,1 | 36 829 | 52,19 | 407 | 2 600 |
| Mercedes-Benz Actros 2652LS RE | 43,0 | 36 663 | 52,71 | 380 | 2 600 |
| FAW J7 28.550 FT/P | 41,7 | 36 352 | 49,36 | 407 | 2 600 |
| Volvo FH520 | 41,1 | 36 416 | 51,84 | 382 | 2 500 |
| Scania R550 A6X4NZ | 40,9 | 36 514 | 43,47 | 404 | 2 800 |
| Powerstar VL 550 AMT | 39,8 | 36 730 | 55,22 | 405 | 2 300 |
| FAW JH6 28.500 FT | 38,4 | 36 480 | 54,62 | 370 | 2 300 |
| Daewoo Maximus KL3TX | 36,8 | 35 956 | 57,54 | 373 | 2 509 |
| Sinotruk Howo-Max 64480 | 35,5 | 36 926 | 53,58 | 353 | 2 300 |
| Foton Auman 560 Air AMT (2.846) | 35,3 | 36 574 | 59,12 | 412 | 2 600 |
| Foton Auman 560 Air AMT (3.083) | 34,6 | 36 614 | 61,85 | 412 | 2 600 |
| Source: Truck Test 2026 results PDF. Values are ACTUAL (not simulated) results: payload productivity, payload and fuel consumption. | |||||
| Power and torque are peak figures from the technical specifications | |||||

